FIX YOUR OVERHEATING HOT TUB
Each year, consumers complain that their spa water gets hotter than the set temperature once the outside temperature gets warm. This condition is commonly referred to as Thermal Creep because it is characterized by a gradual increase in the spa’s water temperature even when the heater is not energized.
The real culprit is the spa’s insulation, not its heater or electronic controls. While the efficiency of our spas’ insulation is a real energy saver during the cooler months, it also requires that the spa owner follow some simple guidelines if their spa water exceeds the set temperature during the warmer times of the year.
To manage Thermal Creep you may:
- If the hot tub is in direct sun be sure to shade the equipment side of the spa as best you can.
- Leave the air controls in the open position when the spa is not in use.
- Vent your cover. Newer covers have removable center seal padding. To remove this padding, open the Velcro on one side of the vinyl pouch and slide the white padding out.
- If your spa does not have removable center seal padding, you may instead place a folded cloth about ¾” (2cm) thick under all four corners of the cover before you lock it down. Opening the cover at night will also quickly cool the water down if desired.
- Cut back filter cycles to one hour each during the summer months.
- Remove some of the insulation to help release internal heat and allow cooler air to flow around the equipment area. Reinstall insulation in the fall months.
- Fill 2-4 empty gallon water jugs with water and freeze them. Place them in your hot tub an hour or so before you want to use it. This will cool it down several degrees relatively quickly. After you are done, put them back in the freezer so they are ready for your next soak.